Travel and run for 11¼, 22½, 30, 45 and 60° offsets, with the multipliers.

True offset, travel, run and roll angle from rise and roll. Or the fitting angle for a set run.

Several pipes through the same offset: where each next one starts so the spacing stays equal.

Center-to-center minus fitting take-outs and weld gaps. Plus take-out of an elbow cut to any angle.

Segmented elbow from straight pipe: cut angle, segment lengths (long and short side) and take-out.

Fall over a run at ¼", ⅛" or any slope per foot, or the slope from a measured drop. IPC minimums.

Add, subtract, multiply and divide feet, inches and fractions.

Rise, run, diagonal, angle and pitch; diagonals and 3-4-5 for squaring.

Convert feet, inches, meters, sq ft, acres, cu yd, gallons, pounds, tons and more.

Phone level and inclinometer: angle, slope % and rise per foot.